Crucial Warning: Always set SP Flash Tool to Download Only mode when flashing this package. Never select Format All + Download under any circumstance, because full formatting erases the protected NVRAM partition holding your phone's unique IMEI certificates, baseband calibration, and Wi-Fi MAC address. In addition, uncheck the preloader partition if your phone already powers on normally to avoid unnecessary bootloader overwrites.
Coolpad 8737 Official Factory Firmware Downloads
8737_6.0.049.P2.170214.8737_6.0.rar
Official factory maintenance release for Coolpad 8737 with MT6735 scatter file. Flash in Download Only mode.
MD5: d894ef8a0f62829fac4cd4556a3a6eb3
Coolpad 8737 SP Flash Tool Restoration Milestones
- Extract 8737_6.0.049.P2.170214.8737_6.0.rar and launch SP Flash Tool as administrator
- Load MT6735_Android_scatter.txt and choose Download Only operation mode
- Uncheck preloader partition to protect bootloader DRAM initialization tables
- Click the Download button to place SP Flash Tool into active listening mode
- Power off phone, hold Volume Down, and connect USB cable to establish VCOM handshake
Pre-Flash Hardware Triage & Safety Checks
- Confirm your hardware model by checking the regulatory sticker under the back cover to ensure it reads Coolpad 8737 or 8737-A00.
- Connect the phone to a 5V/1A wall charger for at least 30 minutes to verify the non-removable 2500 mAh battery holds sufficient voltage above 3.8V.
- Install verified MediaTek MTK VCOM USB drivers on Windows, disabling driver signature enforcement if using Windows 10 or 11.
- Extract 8737_6.0.049.P2.170214.8737_6.0.rar with 7-Zip to a short directory without spaces, such as C:Coolpad_8737_FW.
- Connect the phone using a native rear motherboard USB 2.0 port rather than a loose front-panel hub to prevent communication dropouts during the flash.
- If the phone is deeply unresponsive, inspect the eMMC flash health by performing a read-back test in SP Flash Tool to confirm the storage controller is not stuck in write-protect mode.
MediaTek MT6735P Hardware & Partition Taxonomy
The Coolpad 8737 runs on the 64-bit MediaTek MT6735P platform. Because this factory firmware is installed in low-level MediaTek BootROM (BROM) and Preloader mode using SP Flash Tool, an unlocked bootloader is not required to flash official signed factory images. To initiate communication, power off the phone, press and hold Volume Down, and insert a reliable microUSB cable.
Ready to Flash This Firmware?
Full step-by-step instructions for Coolpad 8737, including prerequisites, error fixes, and screenshots, are on FlashGuideHub's SP Flash Tool guide.
Can also be flashed via YGDP Tool (Coolpad/360): Open YGDP Tool (Coolpad/360) Guide →
Coolpad 8737 Hardware & Archival Questions
Both model identifiers represent the same physical smartphone platform built on the MediaTek MT6735P chipset. The 8737-A00 code is the Chinese regulatory All-Netcom certification variant, which includes CDMA2000 1x/EVDO Rev. A baseband profiles alongside standard GSM, TD-SCDMA, and FDD/TDD-LTE bands.
No. Because flashing takes place in MediaTek BootROM (BROM) and Preloader mode using SP Flash Tool, the computer communicates directly with the chipset hardware before Android OS security controls load. Official factory images matching the hardware scatter can be restored without unlocking the bootloader.
The Coolpad 8737 is equipped with 16GB of eMMC 5.0 flash memory alongside 2GB of single-channel LPDDR3 RAM clocked at 533 MHz. This hardware configuration is matched directly by the memory timings programmed into the official factory preloader binary.